A Zeek plugin to POST logs over HTTP. The logs are posted in native TSV ASCII format. The plugin uses HTTP chunked encoding to first post the Zeek log header then it streams log lines as HTTP chunks as they become available.

If the connection closes or resets, the plugin attempts to reconnect and transmit data where it left off.

The plugin is known to work with with Zeek versions 3.0.0 and newer.

1. Ensure that you have libcurl present on your system (plugin has been primarily developped/tested against libcurl 7.54, but other versions should work too).

2. Build the plugin using the following commands:

   $ ./configure
   $ make

The configure uses zeek-config to determine the path to your Zeek distribution. If for some reason that is not present you can pass path via the --zeek-dist argument to configure.

From source: If you've built the plugin yourself following the steps above, make install will install the plugin. (Of course, this requires building the plugin locally to the Zeek host it will run on).

From binary release: If you're installing a binary release of the plugin (such as Zeek_TsvHttp-0.5.tar.gz), then do the following after copying the package on to the Zeek host:

$ sudo mkdir -p $(zeek-config --plugin_dir)
$ cd $(zeek-config --plugin_dir)
$ sudo tar oxzf path/to/plugin/Zeek_TsvHttp-0.5.tar.gz

To verify the installation, run zeek -N Zeek::TsvHttp and you will see the same output as below if the installation was successful.

$ zeek -N Zeek::TsvHttp
Zeek::TsvHttp - Plugin to POST Zeek logs via HTTP (dynamic, version 0.5)

To be documented.

Add the following to the end of your local.zeek file:

@load Zeek/TsvHttp

# Set this to the URL of your HTTP endpoint
redef LogTsvHttp::url = "http://localhost:9867/space/default/zeek";

By default, all log streams will be sent.

You can redefine the exclude_logs and send_logs variables for finer-grained selection of streams to send.

For example, to send only the conn and dns logs:

redef LogTsvHttp::send_logs = set(Conn::LOG, DNS::LOG);

or to send all but the loaded_scripts log:

redef LogTsvHttp::exclude_logs = set(LoadedScripts::LOG);

The LogTsvHttp::url endpoint can be overridden on a per-log basis by instantiating a Log::Filter and passing the URL in its configuration table. For example:

@load Zeek/TsvHttp

# Set this to the URL of your HTTP endpoint
redef LogTsvHttp::url = "http://localhost:9867/some/endpoint";

event zeek_init() &priority=-10
{
    # handles HTTP
    local http_filter: Log::Filter = [
        $name = tsv-http",
        $writer = Log::WRITER_TSVHTTP,
        $path = "http",
        $config = table(["url"] = "http://localhost:9877/other/endpoint")
    ];
    Log::add_filter(HTTP::LOG, http_filter);

    # handles DNS
    local dns_filter: Log::Filter = [
        $name = "tsv-dns",
        $writer = Log::WRITER_TSVHTTP,
        $path = "dns",
        $config = table(["url"] = "http://localhost:9887/and/another/endpoint")
    ];
    Log::add_filter(DNS::LOG, dns_filter);
}